4 Axis I.T.C.™ Tecnology

4 Axis I.T.C.™ Tecnology

I.T.C.™ 
The I.T.C.™ System compensates for the natural taper that is produced by the water jet while cutting. The I.T.C.™  enables the operator to enhance the squareness of the cut material, top to bottom, while allowing highest possible cutting feed rates. The water jet position is compensated up to 2 degrees, via the NC control of the motion system. This ensure a high quality part at low cost.

During the I.T.C.™ compensation, the jet is also directed towards the piece in order to reduce the "Tail Delay" effect as well as the accelerarion-deceleration ramp times around the corners, for faster and more economical cutting cycles.


This site uses cookies to manage, improve and personalize your browsing experience of the website.
For more information about how we use cookies and how to remove them, consult our policy on cookies.
For permission to use cookies on this site click the button "OK".
OK